luna@ironflon.com    +86-577-62802555
Cont

Have any Questions?

+86-577-62802555

Jun 28, 2024

The causes of wire and cable explosions and fires

The insulation layer of power cables is composed of various combustible substances such as paper, oil, hemp, rubber, plastic, asphalt, etc. Therefore, cables have the possibility of fire and explosion. So next, the Huaqiang Cable editor will introduce the following 6 reasons for wire and cable fires and explosions:

1. Insulation damage causes short circuit fault: The protective lead skin of power cables is damaged during laying or the cable insulation is mechanically damaged during operation, causing insulation breakdown between cable phases or lead skin, and the generated arc causes the insulation material and the outer protective layer material of the cable to burn and catch fire.

 

2. Long term overload operation of cables: Long term overload operation causes the operating temperature of the cable insulation material to exceed the maximum allowable temperature for normal heating, resulting in insulation aging and drying of the cable. This phenomenon of insulation aging and drying usually occurs throughout the entire cable line. Due to the aging and drying of cable insulation, the insulation material loses or reduces its insulation and mechanical properties, making it prone to breakdown, ignition, and even simultaneous combustion along the entire length of the cable.

 

3. Oil immersed cables may experience oil leakage due to height differences: When oil immersed cables are laid with a large height difference, oil leakage may occur. The result of flowing causes the upper part of the cable to dry up due to the loss of oil, which increases the thermal resistance of this part of the cable and causes the paper insulation to carbonize, leading to premature breakdown. In addition, due to the downward flow of oil in the upper part, space is created at the upper cable head and negative pressure is generated, making it easy for the cable to absorb moisture and make the ends damp. The accumulation of oil in the lower part of the cable generates significant static pressure, which leads to oil leakage at the cable head. Dampness and oil leakage of cables increase the probability of faults and fires.

 

4. Insulation breakdown of the intermediate joint box: The intermediate joint of the cable joint box may oxidize, heat up, and glue flow during operation due to poor crimping, weak welding, or improper selection of joint materials; When making cable intermediate joints, the quality of the insulation agent poured into the intermediate joint box does not meet the requirements. When pouring the insulation agent, there are pores in the box and the cable box is poorly sealed or damaged, leading to moisture leakage. All of these factors can cause insulation breakdown, form a short circuit, and cause the cable to explode and catch fire.

 

5. Burning of cable head: Due to moisture and dirt accumulation on the surface of the cable head, the porcelain sleeve of the cable head is broken, and the distance between the lead wires is too small, causing flashover and ignition, resulting in burning of the surface insulation of the cable head and the insulation of the lead wires.

 

6. External sources of fire and heat can cause cable fires, such as the spread of fires in oil systems, explosions in oil circuit breakers, spontaneous combustion of coal powder in boiler or coal conveying systems, baking of high-temperature steam pipelines, chemical corrosion of acids and bases, welding sparks, and other ignition sources, all of which can cause cable fires.

Send Inquiry