If the wire connector is easy to burn out, it means that there is actually a problem with this line, either the heat is severe, or the wire is too thin.
Cause of burnout:
When normal wires come out of the connector, local wires will become extremely hot. However, if your wire diameter is thick enough, no matter how big the connector is, the heat will not be enough to cause the wire to burn out, so you must find the cause of the burnout.
1. Load overcurrent
If you have a clamp ammeter on hand, you can measure the current passing through the wire to see if the current has exceeded the rated current of the electrical equipment. If there is overcurrent, there is some problem with the load, either it is old or the internal structure is partially aged. Case.
Repair as appropriate. If there really are no replacement parts, try to make the wires as thick as possible to solve the problem.
2. Aging of wires
The aging of wires is also a large part of the reason why wires heat up. If the wires age, the insulation becomes worse, and the resistance of the wire becomes smaller, then the current passing through becomes larger, and the resistance at the joint is larger. The same current passes through the joint of this wire. The fever was very severe.
So no matter what you use to connect this wire, there will be problems. The simple way is to change a wire to one with a larger diameter.
Which methods are reliable for wiring?
If there is no problem with the load, there is no overcurrent or aging of the wires, but various problems arise due to poor handling of the connectors, then you should consider using other methods to connect them.
1. Use a soldering iron
It is more convenient and safer to use a soldering iron for wiring or welding. The contact surface does not need to be too large. As long as the two wires touch each other, use the soldering iron to insulate them. There is no need to use two wires as usual. The wires need to be wound several times to connect them together. Try to use this method if conditions permit.
2. Use terminal blocks
The second is to use the terminal block. To use the terminal block, just snap the two ends into the terminal block and use a screwdriver to tighten the screws at both ends. It is also a very convenient tool. If you have the conditions, you can buy one, and it is also very easy to handle when doing insulation. .
Other methods are not recommended, because making joints will cause the resistance to increase and heat will occur.






